Filter
Top Products
u
Remove locking device
Fig. 37 (2)
by twisting it.
u
Snap panel
Fig. 37 (1)
into place on the door.
u
Turn cover
Fig. 27 (6)
180° from the handle side, place it
on top from the outside and snap into place.
8.9 Aligning the door
u
Unscrew center screw on lower part of bearing bracket
Fig. 32 (20)
.
u
Align the doors flush with the appliance housing using
the two oblong holes in the lower bearing bracket
Fig. 32 (20)
as a guide if needed.
u
Tighten the screws fully.
9 Adjusting the door opening
angle
The appliance is delivered with a door opening angle of
110°. If the angle needs to be limited to 90° an opening
limiter must be used on the soft stop mechanism. Carry
out the following steps for all soft stop mechanisms on the
appliance (the top soft stop mechanism is illustrated):
Removing the soft stop unit
u
Open the door.
Fig. 38
NOTICE
Risk of damage!
If the door seal is damaged the door may not close
properly and the level of cooling is insufficient.
u
Do not damage the door seal with the screwdriver!
u
Release panel
Fig. 38 (1)
using slotted screwdriver and
remove.
w
The panel hangs above the damper bracket.
Fig. 39
u
Unscrew spacer
Fig. 39 (10)
.
u
Push panel forward over the damper bracket
Fig. 39 (4)
in the direction of the appliance.
u
Engage locking device
Fig. 39 (2)
into place inside
oblong hole.
w
The locking device prevents the hinge from snapping
shut.
u
Unscrew cover that is on the hinge side
Fig. 39 (5)
until
the first notch using a screwdriver.
w
The bolt will become visible.
u
Push bolt
Fig. 39 (3)
out from below.
u
Press damper bracket
Fig. 39 (4)
in the direction of the
door.
u
Completely loosen cover that is on the hinge side
Fig. 39 (5)
and remove.
u
Remove panel
Fig. 39 (1)
.
u
Unscrew soft stop unit (2 x Torx 15)
Fig. 39 (6)
.
u
Slightly pull out soft stop unit, push it towards the
handle side and open it out.
Fit opening limiter:
Fig. 40
u
Fit opening limiter (90°)
Fig. 40 (21)
supplied: insert it
into the soft stop mechanism from the side and push in
until it audibly snaps into place.
Re-attaching the soft stop mechanism:
Adjusting the door opening angle
23