Filter
Top Products
MODEL C24EA - GENERAL
F35453 (July 2008) Page 4 of 68
Other chemical properties in water supplies can also
affect good steam generation and vary from within
each state and locality.
The water level probes in the steam generator use
ions in the water to detect the water level. Do not use
fully demineralized or de-ionized water since it is
non-conductive and the water level can not be
detected.
NOTE: The use of strainers, or filters will not remove
minerals from the water.
Steamers that operate over a long period of time
without the benefit of properly conditioned water, and
have developed a heavy scale build up, should be
cleaned before connecting to a conditioned water
supply.
REFERENCE MATERIAL
For replacement parts, refer to Catalog of
Replacement Parts F35454.
For operation, cleaning and maintenance
instructions, refer to Installation and Operation
Manual F35430.
LUBRICATION
Component Lubrication Type
All NPT Fittings Pipe Thread Sealant, Loctite 565
Door Handle
Sliding Bracket
Lubriplate 630AA
TOOLS
• Standard set of hand tools.
• VOM with A/C current tester (any quality VOM
with a sensitivity of at least 20K ohms per volt
can be used).
• Anti Static Kit, Part No. TL - 84919.
Special
• Torque Wrench - Capable of measuring
70 in-lbs.
• Aluminum Foil Tape - (McMaster-Carr Part No.
7631A21) or equivalent.
• Single use Constant Tension Band Clamps for
the specific hose size being used. Refer to parts
catalog for part number.
• Pressure Gauge Assembly
• Low Pressure Gauge - 0 to 5 psi.
recommended (Grainger Part No. 2C641).
• Water Hose Coupling - swivel type
(Grainger Part No. 4KG87).
• Reducer Bushing (Grainger Part No.
6MN61).
• Pipe thread sealant (as required).