Filter
Top Products
10
SURFACE BURNERS
A spark electrode ignites each
surface burner. This control
eliminates the need for contin-
uous open flame pilots. For
added safety and convenience,
each burner is designed with an
electronic re-ignition system.
This feature enables any burner
to automatically re-light in the
event it is accidentally extin-
guished.
In case of a power outage, the
surface burners can be re-lit
manually, see page 12.
W OLF T OP S URFACE O PERATION
DUAL-STACKED
BURNER ASSEMBLY
The unique dual-stacked burner
design combines all the burner
parts in one assembly piece.
Large burners provide a Btu/hr
rating of 15,000 on HIGH.
Small burners provide a Btu/hr
rating of 9200 on HIGH. All
burners have simmer settings.
A distinguishing feature of
Wolf's low Btu/hr control is its
constant, low heat output
without continuous ignitions.
Flame diameter remains full
size; only the heat output is
lowered.
The Simmer gives you ultimate
control for preparing your
food.
After cleaning or removing
burner parts for any reason, it
is extremely important that you
reassemble burners correctly.
The burner cap has a special
orientation and should be
seated flatly. Match notches on
the burner cap to align with the
tabs on bottom of burner.
This patented dual-stacked
burner configuration makes it
possible to enjoy cooking at full
flame as well as maintaining
control while simmering at the
lowest flame setting.
BEFORE USING FOR
THE
FIRST TIME
Clean your range thoroughly
with hot water and a mild
detergent. Rinse and dry with a
soft cloth. This removes any
residual oil and grease left on
the surface from the manufac-
turing process.
• Refer to Top Surface Care on
page 14.
• Check that the burner caps
are positioned correctly.
• Griddles and French Tops
need to go through a "burn in"
to clean oils from the bottom
of these assemblies. See pages
18-21 for cleaning directions.
CAUTION
Failure to position the
burner parts correctly could
cause flames or gas to
escape and burn between
parts, resulting in poor
combustion or damage to
your range.
BURNER CAP
IGNITER
SEALED BURNER
ALIGNMENT
TABS
Dual-stacked sealed burner assembly