
Installation, cont’d
SGS 408 Switcher • Installation2-4
Tabletop/desktop mounting
For tabletop or desktop placement, install the self-adhesive rubber feet/pads
(provided) onto the four corners of the bottom of the enclosure.
Cabling
Up to eight input devices that produce component video, RGsB, RGBS, or
RGBHV signals, can be connected to the switcher. The switcher can be
connected to up to four output devices (two program and two preview) that
accept RGBS or RGBHV signals, and, optionally, to one program output device
that accepts DVI signals.
To cable the switcher, do the following:
1. Use BNC connectors to attach cables from the input devices to the switcher.
Figure 2-3 shows the connection options.
Figure 2-3 — Input connections
2. Use BNC connectors, 15-pin HD connectors, or a DVI connector to attach
cables from the switcher to the output devices. Figure 2-4 shows the
connection options.
Figure 2-4 — Output connections
Figure 2-5 shows a typical system installation and its cable connections.
See the next chapter, “Operation”, for information on configuring and using the
switcher.
RGBS RGBHV
15-pin HD
DVI-D
RGsB
(input only)
RGBS RGBHV
Component
R/R-Y
G/Y
B/B-Y
R/R-Y
R/R-Y
R/R-Y
G/Y G/Y G/Y
B/B-Y
B/B-Y B/B-Y