Operation, cont’d
SGS 408 Switcher • Operation3-6
6. Depending on the input type, color matrix, Beta-cam control, and Luma/
Setup control can be set by pressing the button below each control
(figure 3-7). Color matrix control may be set to either the ITU 601 or ITU 709
standard, Beta-cam control may be set on or off, and Luma/Setup control
may be set to either .700V or .714V, on or off.
There are four preset component video types available for selection. The
settings for each control can be changed by pressing the button below it. If
needed, a custom component setting may be made.
7. To return to the default LCD menu, press the Exit button, then press the
Next button, then press the Exit button, or wait 16 seconds until the
submenu times out.
Selecting the output rate
To select the output rate, do the following:
1. Press the Menu button.
2. Press the Out Rate button (figure 3-9).
True(DVI) only 1280 x 1024
60 Hz
Input Out Out Test
Next Config Rate Sync Pattern
Figure 3-9 — Selecting the output rate
3. To select the output resolution, turn the right adjustment knob. The
following output rates are available:
640 x 480
1,2,3,4
852 x 480
2,4
1360 x 765
2,4
720p
2,4
800 x 600
1,2,3,4
1024 x 768
1,2,3,4
1365 x 1024
2,4
1080i
1,2,4
832 x 624
2,3,4
1280 x 768
4,5
1400 x 1050
1,2,4
1080p
2,4
848 x 480
2,4
1280 x 1024
1,2,4
576p
1,4
1
at 50 Hz;
2
at 60 Hz;
3
at 75 Hz;
4
locked to the current vertical refresh
rate of input 1;
5
at 56 Hz
4. To select the refresh rate, turn the left adjustment knob. The available
refresh rates depend on the output resolution. The locking feature will lock
the output rate to the vertical refresh rate of input 1.
5. Pressing the Output Rate button allows the scaler to be set to True DVI or
Enhanced mode. True DVI is only available for resolutions of 1024 x 768
and above. When using the optional DVI output card, control must be set to
True DVI.
6. To return to the default LCD menu, press the Next button, then press the
Exit button, or wait 16 seconds until the submenu times out.
Selecting the output sync format and polarity
To select the output sync format, do the following:
1. Press the Menu button.
2. Press the Out Sync button (figure 3-10).
