Filter
Top Products
Appendix A Rack Mounting the Counter
Rack Mounting the Counter
A-2 Operating Guide
A
Rack Mounting the Counter
You can mount the Counter in a standard 19-inch cabinet using one of two
optional kits available from Agilent:
• Option 1CM Rack Mount Kit (Agilent 53150-67001 Rack Adapter Kit)
for single instrument (Half Module) rack mounting. Instructions and
mounting hardware are included with the rack-mounting kit.
• Agilent 5061-9694 Lock Link Kit for two-instrument, side-by-side rack
mounting. Instructions and mounting hardware are included with the
rack-mounting kit. (Two Option 1CM Rack Mount Kits are also
required when mounting two instruments.)
To rack-mount the Counter, you must first remove the front and rear
rubber bumpers, the carrying handle, and the handle pivots:
NOTE Unlike the hardware used elsewhere in this instrument, all hardware
used to attach the rack mounts and the handle pivots is metric.
1 Rotate the handle to its vertical position, pull the ends outward, and set
it aside.
2 To remove the rubber bumpers, lift the center of the top of the bumper
upward, stretch a corner of the bumper diagonally, then slide it off the end
of the Counter.