Filter
Top Products
Appendix C Using the Battery Option
Replacing the Batteries
Operating Guide C-7
C
3 Holding one of the batteries so the battery terminals are to your right and
the plus sign at the terminal end is facing away from you, insert the
left-hand end of the battery into the taller end of the battery sled with the
far side of the battery against the far side of the sled. Lower the right end
of the battery into the sled, and push down on the battery until it is down
as far as it can go. Insert the second battery next to the first one in the
same manner.
NOTE The batteries fit snugly into the sled, so it is important to keep them
aligned with the sides of the sled. If you attempt to insert a battery, and it
is not parallel with the sides of the sled, it will bind.
4 When both batteries are fully inserted in the sled, insert the sled into the
battery-chamber opening in the Counter’s back panel (terminal end first).
5 Slide the sled into the battery chamber until you can start the thumb-
screws into the threaded holes in the Counter’s back panel (turn the
thumbscrews clockwise). You may have to push against the back end of
the battery sled to insert it far enough for the thumb screws to contact the
back panel.
6 Tighten the two thumb screws on the battery sled until both thumbscrews
are fully hand tight and the back cover of the battery sled is flush against
the Counter’s back panel.
NOTE The thumbscrews require a considerable amount of turning force, since
they push the battery sled into the Counter and also insert the battery
terminals into the battery connectors as you turn them. To prevent the
battery sled or the terminals from binding or jamming, either turn both
thumbscrews simultaneously, or alternately turn the thumbscrews
one-half turn each, until the battery sled is fully inserted.