Filter
Top Products
Chapter 2 Operating Your Frequency Counter
Measuring Frequency
Operating Guide 2-13
2
NOTE When the frequency of a signal applied to the Channel 2 input exceeds the
maximum rated frequency for the instrument, the Counter displays
CH2 TOO HIGH.
4 To measure the frequency of a signal applied to the Channel 1
input, press the Chan Select key.
CHANNEL 1 is displayed momentarily, and the Ch 1 and Freq annunciators
are activated. If a signal is presently applied to the Channel 1 input, the
measured frequency is then displayed. If no signal is applied, CH1 NO
SIGNAL is displayed until an input signal is connected to the Channel 1
input connector.
FREQ
Gate
Chan
Select