Filter
Top Products
Installation
18
Adjustments
Before applying power to the appliance for the first
time, check for the following conditions:
j All āelectricalā safety provisions have been adĆ
hered to and the electrical connections are
correct.
j Water is connected, turned on and all of the
connections are water tight.
j The āpanā holders are āinserted āinto the oven
cavity.
j Cardboard has been removed from oven cavĆ
ity.
j Gas has been turned on, if gas unit.
DOOR ADJUSTMENT
The door catch may be adjusted in and out using
the following procedure:
1. Flip the rubber boot on the catch towards you.
2. Loosen the locknut to make adjustment.
3. Rotate the catch clockwise or counter clockĆ
wise to get proper adjustment.
4. Retighten locknut, assuring the catch is vertiĆ
cal.
5. Flip the rubber boot back into position.
The hinges can also be adjusted as follows:
1. Loosen the two 1/4Ć20 bolts on the top of the
hinge plate and the two bolts on the bottom
hinge plate.
2. Apply pressure to the door on the corners to
get the proper seal. While pushing, tighten the
bolts in place.
Figure 11