Filter
Top Products
Maintenance
30
Deliming (BCXĆ14 units only)
Deliming of the steam generator is the single most
important preventative maintenance task. Lime
will build up inside the steam generator, reducing
efficiency and causing damage to the level control
system. This oven comes equipped with a Delime
lamp to indicate when the steam generator needs
to be delimed. The Delime lamp will flash when the
steam generator has been run for the preset interĆ
val. The flashing Delime lamp does not impede the
operation of the oven, you can use the oven norĆ
mally when the lamp is flashing. You may choose
the best time to start the deliming process.
WARNING!!
Problems caused by insufficient deliming
are not covered by the warranty.
Be sure to use a nonĆdiluted deliming agent such
as Lime Away" by EcoĆLabs or Lime Out", by US
Chemical.
WARNING!!
Deliming solutions are hazardous and
can cause burns to the skin and eyes.
Wear protective clothing and eyewear.
SEMIĆAUTO DELIME PROCESS
NOTE: The Delime lamp must be flashing to start
this process.
WARNING!!
DO NOT initiate the deliming sequence
until the boiler is preheated.
WARNING!!
DO NOT cook while deliming.
1. The boiler must be preheated prior to deĆ
liming. If the boiler is not already preheated,
place the oven in the Hot Air mode for approxiĆ
mately 10 minutes.
2. Be sure the container delivering the deliming
agent to the appliance is full.
3. Be sure the door is open.
4. Turn the oven to Cool Down mode. Press and
release the Steam On Demand button. The
Delime lamp will flash faster, acknowledging
the action.
5. Turn the oven to the OFF mode.
The remainder of the procedure is automatic. The
Delime lamp will stay illuminated while the process
is active. Once the process has been started, the
oven cannot be used until the process is comĆ
plete. The total process time is approximately 45
minutes. When the process is completed, the DeĆ
lime lamp will turn off indicating the appliance can
now be used normally.