Filter
Top Products
-24-
Revision 4/F3576 © Moffat Ltd, December 2004
6.2 ACCESS
6.2.1 CONTROL PANEL
Hold thermostat faulty
With the power switch on and illuminated,
‘Roast ‘n Hold’ switch on and illuminated, and
the roast (180 minute) timer set to hold, check
that the hold indicator is illuminated.
With a cold oven (ie room temperature) check
that the oven burners are on. If burners are
not operating, check the voltage at terminal 2
of the hold thermostat. If there is no voltage
then check wiring.
If the voltage is correct, and the thermostat is
adjusted above oven temperature, then check
for output voltage at terminal 1 (bottom) of
hold thermostat. If there is no voltage then
the thermostat is faulty—replace.
6.1.14 HOLDING TEMPERATURE
INCORRECT
1) Undo the screw on the left hand side of
the control panel.
6.2.2 FAN BAFFLE
1) Open the oven doors and remove all racks
and trays from the oven.
2) Remove the four baffle securing screws
from the rear of the oven.
2) The control panel can now hinge open
along its right hand edge.
Figure 6.2.1
3) Withdraw the baffle from the oven.
Figure 6.2.2
One screw
6.2.3 RIGHT HAND ACCESS PANEL
1) Undo the six screws securing the access
panel to the right hand side panel, and
remove.
Figure 6.2.3