Filter
Top Products
W
HAT IS THE
SC-5 S
URE
CUT?
CONTINUED
DESCRIPTION 2-3
UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
The larger diameter flywheel used on the servo cutter offers
the potential of higher surface speeds at dramatically lower
blade rpm’s with high cutting torque. The typical grey area
between on-demand cutting and flywheel cutting (150 cpm
on-demand up to 300 cpm flywheel), typically seen in DC dri-
ven clutch\brake cutter is eliminated.
It should not be necessary to cut in on demand mode in excess
of 150 cuts per minute which will greatly save on premature
wear to the system. Not only does this cutter offer optimum
blade surface speed throughout an extremely wide cuts per
minute range, but extreme accuracy throughout.
The added benefit of the 24 inch diameter by one inch thick
aluminum wheel is the stored inertia which adds power for
cutting larger profiles and tubes. The size of the wheel actual-
ly adds horsepower to the system. Due to the use of 10:1 gear
reduction, the servomotor is made extremely efficient and eas-
ily able to handle this weight with out detrimental effects.