Filter
Top Products
SC-5 SURE CUT Servo Knife Cutter UGE059/1003
5-8 MAINTENANCE
This tray is built into the cutter assembly as a simple method
of applying lubrication to your blade during cutting cycles.
Depending on cut rate and type of material and lubrication,
the area will need to be cleaned on a regular basis and the
lubricant replaced. Open the clear guard windows and, using a
shop vac or other similar equipment, remove all liquid and
solids from the cutting chamber and around the bushings.
Replace the lubricant. For more information, see Blade and
Bushing Lubrication, Appendix D.
CLEANING THE
BLADE TRAY
(OPTIONAL)
Check the shafts on the slide rail system. Even though these
shafts are stainless steel, it is recommended that a light oil
(WD-40 or similar) be applied to the shafts as needed. Wipe
off any excess.
LUBRICATING
THE
SLIDE RAIL
S
YSTEM
(OPTIONAL)
Optional blade
lubrication system
Optional slide base
assembly with posi-
tion locking mecha-
nism