Filter
Top Products
UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
OPERATION 4-3
Before you start daily operation of the servo cutter, you need
to perform preventative maintenance. Necessary maintenance
is described in the Maintenance section of this Users Guide,
see preventative maintenance, Section 5.
Daily maintenance includes:
● Inspecting the cutter blades
● Inspecting the blade mounting hardware
● Making sure the cutter bushings are properly secured
● Inspecting the closure latch on the knife guard
● Checking cutter alignment with extrusion line
● Performing any floor lock adjustments as needed
These items and weekly, monthly, and semi-annual mainte-
nance procedures are detailed in the Maintenance section of
this User Guide.
Plug in the power cord to restore power after any
required maintenance.
Turn on the main power. The cutter control will
bootup. The amber power on light illuminates.
While the cutter is booting up, perform the next three steps:
Make sure the E-Stop button is in the out,
extended position.
Make sure that the Cut Enable is Off.
If necessary, press button to display off.
Press Start Cutter button. The light in the button
should light. On SC-5 cutters, the cutter head will make
one revolution until it finds its home offset position.
BEFORE
STARTING
WARNING: Be sure that power to the SC-5
cutter is OFF when doing any maintenance on
the servo cutter. Follow all safety rules when
performing any maintenance on this equip-
ment.
P
OWERING U
P
NOTE: You can watch the servo motor amplifier's
status screen during bootup through the
window on the back of the electrical enclo-
sure. This display gives information that may
be useful if you have a problem. See the
Troubleshooting section.
1
2
3
4
5
Continued