Filter
Top Products
6-14 TROUBLESHOOTING
SC-5 SURE CUT Servo Knife Cutter UGE059/1003
CHECKING THE
ENCODER
When the encoder is working properly, the encoder LEDs on
the control panel light or flicker as the encoder wheel moves
and generates signals. If the LEDs do not light when the
encoder wheel moves:
Check all connections.
Check the encoder cable for damage.
If neces-
sary, replace.
Check the connector that attaches the cable to
the encoder.
Internal wiring may be shorted out if this
connector is not handled properly.
Check the encoder itself. There should be no play
in the shaft.
If all else fails, contact Conair Customer Service. See
Appendix A.
WARNING: Delicate equipment
The encoder is a delicate piece of equipment.
Any rough handling can damage fragile parts.
3
1
2
4
5
Continued