Filter
Top Products
OPERATION 4-7
Reset Softkey3
Under the counter, on the right is a soft key labeled Reset.
Pressing this key will zero the counter.
EXIT or PREV, fixed function keys return the display to the
Parts Select screen.
BATCH SCREEN
By pressing softkey3 located under the word Batch on the
Parts Select Screen, a six-decade Batch counter is available.
Additional information on how to access this screen can be
found in the operator display overview in Appendix E of this
manual.
This is typically used to count the pieces required to fill a car-
ton, with the product being cut. The batch counter counts up
to the batch preset and resets to zero. As the accumulated
count reaches the alarm preset the batch pre-warn output-3
energizes then when the batch preset is reached the batch
complete output-2 briefly energizes and both outputs turn
back off. Sample/Manual cuts are not counted. When enabled
the count continues to accumulate even if the batch display is
not being viewed. It is also possible to turn this counter off or
on.
Change Softkey1
Under the counter, on the left is a soft key labeled Change.
Pressing this key displays the Select Batch Area screen. The
operator can then choose to set the batch or alarm preset.
On/Off Softkey2
Under the counter near the center is a soft key labeled On or
Off. Pressing this key while On is displayed will disable the
counter. Likewise pressing this key while Off is displayed
enables the counter.
Reset Softkey3
Under the counter, on the right is a soft key labeled Reset.
Pressing this key will zero the batch counter.
EXIT or PREV, fixed function keys return the display to the
Parts Select screen.
CONTROL
INSTRUCTIONS
BATCH
SCREEN
CONTROL
INSTRUCTIONS
TOTAL SCREEN
CONTINUED
Continued
UGE059/1003 SC-5 SURE CUT Servo Knife Cutter