Filter
Top Products
UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
INSTALLATION 3-11
CHECKING THE
ALIGNMENT OF
THE
BUSHINGS
For more information about
setting and adjusting the gap
for the bushings, see About
Cutter Bushings in the
Appendix C.
Checking the Alignment of bushing to blade
Once you are sure that the blade will easily clear the bush-
ings as it goes through the space you should then make
some test cuts to insure quality.
Close the safety cover.
Turn on the Power (Rotary main disconnect).
Press the Green start button.
Do several test cuts by pressing the manual
cut button.
Check the quality of the cuts. Adjust the bush-
ing if necessary.
1
2
3
4
5