Filter
Top Products
OPERATION 4-23
UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
CONTROL
INSTRUCTIONS
SCALE
D
ISTANCE
DISTANCE SOFTKEY
By pressing the soft key located under the word Dist. on the
Scale Value Screen, the scaled distance is available. This value
must be set after a U/M change. Additional information on
how to access this screen can be found in the Maintenance
Area of the operator display overview in Appendix E of this
manual.
The number shown is the current distance value, i.e. the cir-
cumference of the measuring wheel or distance per revolution
of the encoder. A cursor will appear in the least significant
digit.
Exit or Prev- if no change is required press Exit or Prev to
return to the Scale Value screen.
Raise will increase the value by 0.001inch. The key can be
pressed once for each 0.001inch increment required or held
down to scroll up. Releasing the key will freeze the value at
the last value.
Lower will decrease the value by 0.001inch. The key can be
pressed once for each 0.001inch decrement required or held
down to scroll down. Releasing the key will freeze the value
at the last value.
Numeric keys
Key in the distance desired and press enter. The decimal place
is fixed so remember this when entering the value. If you
require 12.000 inches you must key in 12000 and then press
enter. Keying only 12 will set the distance to 0.012 inches.
Enter or Delete?
If the keyed in number is correct press the enter key for it to
be accepted and return to the Scale Value screen. If it is wrong
press the delete key and the previous value will reappear.