Filter
Top Products
3. Cup Turret. Release the catch securing the cup drop unit
and swing the unit away from the door. Remove the cup
stack assembly from its packaging and carefully place it onto
the cup drop unit. Ensure that the flat on the turret drive
shaft locates with the flat in the cup turret mounting block.
Remove the lid and fill the tubes with the correct size cups
for the type of cup catcher fitted to the machine. Allow the
cups to drop into the tubes directly from the packaging. DO NOT touch the cups
with your hands.
Important: Do not fill the tube directly above the cup dispense position. Allow
the cup turret motor to rotate a full tube to the cup dispense position when the
machine is powered up. Rotating the cup turret by hand will damage the
mechanism.
Note: If paper cups are being loaded, each pack of cups must first be inspected
for damage to the cup rims. Damaged cups must not be used.
4. Insert the safety key (a) supplied with the machine into the
door switch as shown. The machine is now on. The cup
turret mechanism will index the first available full cup stack
to the dispense position and drop the cup stack into the cup
drop mechanism. Fill the remaining empty cup stack with
cups and replace the lid.
5. Swing the cup turret assembly back to its operating position. Ensure that the unit
is held securely by the catch.
6. All Models: The water inlet valve will open and
the heater tank will start to fill. As the water
heats, ensure that no water overflows from the
heater tank overflow pipe into the waste bucket.
When the machine has powered up, the LCD
will display the message as shown opposite.
Check the system for leaks.
Note! The machine has a safety cut-out which will only allow the heater tank to
fill for a maximum of two minutes. If after software power-up the heater tank has
not filled within this time, the mains power supply should be switched off and then
on again to reset the heater tank time-out.
Espresso Models: As the machine initialises a small amount of water is pumped
through the system and is discharged into the waste bucket. When the machine
enters standby mode remove the bucket and empty the contents before refitting
to the machine.
Operators Manual
9
a