Filter
Top Products
3. Remove the brewer dispense pipe from the dispense
head. Pull down the brewer release pin (b) and
carefully lift the brewer unit up and clear of its locating
bracket.Thoroughly clean the external surfaces of the
brewer.
4. With the brewer unit removed, clean the area
surrounding its locating bracket. Refit brewer to
machine and refit the outlet pipe to the dispense head.
5. Switch on the power to the machine using the safety key. The brewer chamber
will return to its closed position. Referring to the instructions supplied with the
product, pour the recommended amount of de-staining fluid directly into the top
of the brewer chamber. Flush the brewer using the Brewer Clean switch (4)
following the procedure outlined on page 33.
6. Press and hold the Brewer Open switch (2) to index the brewer to its fully open
position. Remove the safety key to switch off the power to the machine. Feed the
filter paper through the paper feed mechanism. Switch on the power to the
machine using the safety key. Filter paper will index automatically and the brewer
chamber will return to its closed position. Refit the brewer guard.
7. Remove the brewer waste container and empty its contents. Clean waste bucket
and refit into machine. Remove the safety key and close the door.
N.B. Every time that the brewer waste container is emptied the waste counter
must be reset. Restore power to the machine using the safety key and press
button 12 on the service keypad. Two audible bleeps confirm that the counter
has been reset to zero.
4.7 Paperless Brewer Unit - Cleaning Procedure
1. Switch on the power using the door switch safety key. Press and hold the Brewer
Open switch (2) located in the service keypad on the rear of the door until the
brewer chamber reaches its fully open position.
Remove the door switch safety key to switch off the
power to the machine. Remove the brewer guard.
2. Carefully remove the water outlet tubes c/w water
pipes (a) from the tea and coffee chambers. Lift the
latch bar (b) and remove the brewer chambers/wipe
arms assembly.
Operators Manual
26
b
b
a