Filter
Top Products
3. Clean the brewer chambers/wipe arms assembly in the sanitiser solution. Rinse
with clean water and dry thoroughly.
4. Carefully slide the brewer chambers/wipe arms
assembly into the brewer unit.
IMPORTANT: The wiper arm lug (a) must be
located between the stainless steel arms (b) as
shown.
5. Re-assemble the water outlet tubes to the coffee and
tea brewer chambers.
Using the clamp supplied, close the tea outlet tube as
shown.
6. Switch on the power using the door switch safety key.
The brewer chamber will automatically index to its
closed position.
Ensure that a suitable container is placed under the
dispense area.
Pour the recommended amount of destaining fluid
directly into the top of both brewer chambers.
7. Remove the clamp from tea dispense pipe. Press the Brewer Clean switch (4)
located in the service keypad on the rear of the door. The machine will
automatically flush through the brewer four times.
If necessary repeat the above instruction until all traces of cleaning fluid are
removed from the brewer chambers.
8. Remove the door switch safety key. Remove and empty the water waste
container. Refit the brewer guard.
Remove the brewer waste container from the machine. Empty the contents.Wash
the waste container thoroughly and where necessary sanitise using the sanitiser
solution. Dry using a clean cloth and refit into the machine.
Operators Manual
27
a
b
b