Filter
Top Products
34312028000
ADJUSTMENTS
CARBONATED WATER FLOW RATE
The carbonated water flow regulators (see Figure 2 and 12), which control carbonated water flow rate into
product blender tanks, are factory adjusted and normally do not require further adjustment. If adjustment should
become necessary, adjust as instructed in the SERVICE AND MAINTENANCE section.
WATER-TO-SYRUP “RATIO” (BRIX) OF DISPENSED PRODUCT
Water-To-Syrup “Ratio” (BRIX) is the water-to-syrup “ratio” of the dispensed product. Adjust BRIX as instructed
in the SERVICE AND MAINTENANCE section.
CO
2
REGULATORS
Primary CO
2
Regulator.
The primary CO
2
regulator (see Figure 2 and 6) regulates CO
2
pressure to the soft drink tanks (also to the
bag-in-box syrup system if used) and also to the secondary CO
2
regulators located inside the Unit. If necessary
to adjust the primary CO
2
regulator, adjust as instructed in the SERVICE AND MAINTENANCE section.
Secondary CO
2
Regulators.
The secondary CO
2
regulators (see Figure 2 and 6) regulate CO
2
pressure to the carbonator and product
blender tanks. If necessary to adjust secondary CO
2
regulators, adjust as instructed in the SERVICE AND
MAINTENANCE section.
ADJUSTING BEATERS MOTORS CURRENTS
Beaters motors currents must be adjusted as instructed in the INSTALLATION section.
PROGRAMMING MAIN MENU SELECTIONS ONTO MESSAGE DISPLAY
The MAIN MENU SELECTIONS (see Table 4) may be brought up on message display as instructed in the
INSTALLATION section.
SETTING ‘‘CLOCK’’ (TIME OF DAY)
NOTE: ‘‘CLOCK’’ (TIME OF DAY) must be programmed into Unit before ‘‘DEFROST’’ (AUTOMATIC),
‘‘SLEEP’’ (SLEEP TIME), and ‘‘WAKE UP’’ (WAKE UP TIME) can be programmed into the Unit.
Program ‘‘CLOCK’’ (TIME OF DAY) into Unit as instructed in the INSTALLATION section.
PROGRAMMING ‘‘DEFROST’’ (AUTOMATIC) SETTINGS INTO UNIT
The automatic defrost system may be programmed into the Unit to occur up to nine different times during a day
with a minimum of two hours between defrost time settings. Program automatic defrost time settings into the
Unit as instructed in the INSTALLATION section.