Filter
Top Products
68312028000
Trouble RemedyProbable Cause
FREEZE CYLINDER DOES
NOT REFILL AT ALL TIMES
WHEN DISPENSING. (cont’d)
C. Lines restricted. C. Sanitize Unit as instructed.
FROZEN PRODUCT
CONSISTENCY VARIES
EXCESSIVELY.
A. Dispensed product BRIX
varying because:
Syrup and/or water flow
regulator sticking.
a. Clean regulator(s).
Primary CO
2
regulator
pressure insufficient.
b. Primary CO
2
regulator must be
adjusted from 80 to 100-psi.
B. Cylinder freeze-up causing
ice formation in center of
cylinder and liquid product
channels around ice
formation.
B. Refer to CYLINDER
FREEZE-UP.
NOTE: DEFROST AFFECTED FREEZE CYLINDER
AS INSTRUCTED.
CYLINDER FREEZE-UP. A. Dispensed product BRIX too
low.
A. Refer to BRIX (Water-to-Syrup)
‘‘Ratio’’ too low.
B. Viscosity of dispensed product
not properly adjusted.
B. Adjust dispensed product
viscosity as instructed.