Filter
Top Products
46312028000
Key on End
of Post
BEATER
Key on End of
Post
Key Slot
on Blade
Scraper blades must be mounted to the beater body as
shown using the perforated edge as the leading edge.
Line up key on end of posts with key slot in scraper
blades.
FIGURE 10. BEATERS AND SCRAPER BLADES INSTALLATION
1. Press applicable ‘‘OFF 1’’ or ‘‘OFF 2’’ switch to prevent more product from entering the applicable product
blender tank.
2. Disconnect Unit syrup inlet line from the applicable soft drink tank.
3. Using a flat blade screwdriver, turn lock counterclockwise to unlock the front access door (see Figure 5),
then open the door.
4. Remove lower front access panel as instructed for access to the applicable carbonated water flow regula-
tor, product shutoff valve, and the product sample valve.
5. Close applicable product shutoff valve to prevent more product from entering the freeze cylinder.
6. Place container under applicable product sample valve. Open the valve and allow all product to be purged
from the product blender tank, then close the valve.
7. Note pressure setting on the applicable secondary CO
2
regulator with 60-psi gauge for the applicable prod-
uct blender tank. Turn regulator adjusting screw out (counterclockwise) until gauge reads 0-psi. Pull up on
the applicable product blender tank relief valve to release CO
2
pressure from the tank.
8. Disconnect carbonated water line from the outlet side of the applicable carbonated water flow regulator.
9. Connect line, long enough to reach to the outside of the Unit, to the water flow regulator outlet, then route
the line to the outside of the Unit.
10. Place end of the carbonated water line, routed to the outside of the Unit, in the container.