Filter
Top Products
PCL
2-7
Some printers offer the Fit to Page setting. When Fit to Page is selected, PCL
emulation or PostScript emulation formats a page using a printable area equal to the
physical page, which is from one edge of the page to the other edge of the page. If
you use this setting, no clipping occurs. In Fit to Page, the PCL emulation logical page
dimensions are equal to the physical page dimensions, as in the Whole Page setting.
The printer holds this formatted image in memory, but when the page prints, the image
is compressed a small amount in both horizontal and vertical directions, and then
centered on the physical page for letter-size paper only. This process creates a small
margin around the image. This artificial margin prevents printing from one edge to the
other, since doing so could contaminate the printer and cause printing problems.
The following illustrations show an image held in memory for printing from one edge
to the other and how the image would actually print based on the Fit to Page setting.
Notice that a small border appears at the edges of the printed page, and the image is
slightly compressed.
Font and Symbol Set Support for the Lexmark C760
and C762
Your printer has 91 resident fonts in PCL emulation, including 89 scalable fonts and
two bitmapped fonts.
Several parameters are used to select a font from the data stream. These include
symbol set, spacing, point or pitch, style, weight, and typeface number. For scalable
fonts, you can vary the size of a font by specifying pitch or point size. For bitmapped
fonts, you must choose the pitch or point size listed on the font sample pages. You can
Formatted Image with Fit to Page Printed Image with Fit to Page
Physical
Page
Edge