Filter
Top Products
Page
19
The controls relate only to video generated in the Motion/Capture module.
Power on Defaults
‘Power on Defaults’ is used to force the analogue and serial outputs from the OmniTek
XR to a chosen video format, within half of one second from power up of the system, and
therefore before the operating system has had time to load. The settings will remain in
force until the OmniTek XR application has initialized, when the program settings will
overwrite the power up settings. To use this feature, just click the button, and the current
settings will be written into the reprogrammable hardware on the OmniTek card.
Panning
By selecting enable, and a speed from 1 to 31, it is possible to have the image/sequence
continually scroll sideways. Reverse lets you change direction. If you keep ‘enable’
selected, and drop the speed to 0, the image will stop scrolling, and remain at its current
position. To return the image to the normal position, clear the ‘enable’ box.
Please note that one side of the image will drop one line during panning, since the image
in effect, wraps around from the right hand edge onto the start of the next line, on the left
hand edge.
Blanking and Ancillary Data Playout
Under 'Use blanking and ancillary data', select 'from internal generator', to have the audio,
video index, wide screen signalling facilities in XR available to insert data onto the output,
and remove the entire ancillary data packets from the original source material. This is
described in more detail on page 58. Note that this is only available if the Advanced
option is present. If this option is not included, then the blanking and ancillary data can
only be generated from the internal generator.