Filter
Top Products
31
Model C300 Important: Operator Checklist
080926
Section 7 Important: Operator Checklist
During Cleaning and Sanitizing
ALWAYS FOLLOW LOCAL HEALTH CODES
Cleaning and sanitizing schedules ar e governed by
your State or local regulatory agencies and must be
followed a ccordingly. The following check points
should be stressed during the cleaning and
sanitizing operations.
WE RECOMMEND CLEANING AND SANITIZING
EVERY 120 DAYS.
Troubleshooting Bacterial Count
j 1. Thoroughly clean and sanitize the machine
regularly, including complete disassembly and
brush cleaning.
j 2. Use all br ushes supplied for t horough
cleaning. The brushes are specially des igned
to reach all product passageways.
j 3. Use the black bristle brush to thoroughly
clean the rear shell bearing located at the rear
of the freezing c ylinder. Be sure there is a
generous amount of cleaning solution on the
brush.
j 4. Using a screwdriver and a cloth towel, k eep
the rear shell bearing and the female hex
drive socket clean and free of lubricant and
product deposits.
j 5. Properly prepare the cleaning and sanitizing
solutions. Read and follow the label directions
carefully. Too strong of a solution may
damage the parts and too weak of a solution
will not do an adequate job of cleaning or
sanitizing.
j 6. Clean and sanitize the syrup lines regularly to
prevent syrup residue build- up that would
restrict the proper flow of syrup.
j 7. On a regular basis, take a b rix reading to
assure a consistent quality product.
Regular Maintenance Checks
j 1. Replace s craper blades that are nicked,
damaged or worn down.
j 2. Before installing the beater, be certain that the
scraper blades are properly attached ov er the
pins.
j 3. Check the rear shell bearing for signs of wear
(excessive product leakage from the rear drip
pans to the front drip tray).
j 4. Dispose o f o- rings or seals if they ar e worn,
torn, or fit too loosely, and replace with new
ones.
j 5. Follow a ll lubricating procedures as outlined in
“Assembly”.
j 6. Check the condenser for an accumulation of
dirt and lint. A dirty condenser will reduce the
efficiency and capacity of the machine. The
condenser should be cleaned monthly by
removing the poly- flo filter and cleaning it.