16 INFO MODE
Test Mode - Self Test
From TEST MODE, press the R4 soft key to access the
“Self Test” screen (Figure 15). From the “Self Test”
screen:
- L1 soft key initiates a comprehensive self test.
The oven will check the door switches, blowers,
magnetrons, and heaters in sequence.
- L2 soft key initiates a door switch test only.
- L3 soft key initiates a blower test only.
- L4 soft key initiates a magnetron test only.
- L5 soft key initiates a heater test only.
When each test completes, the oven will display
PASS or FAIL.
Test Mode - Manufacturing Mode
Press the R3 soft key to place the oven in
MANUFACTURING MODE (Figure 16). When in
MANUFACTURING MODE
, the following tests and
settings can be accessed:
- Microwave leakage test
- Microwave power test
- Burn in
- Serial number edit
- Temperature measurement (F or C)
- Self test (same as
TEST MODE).
- Erase/default oven settings
Microwave Leakage Test
Press the L1 soft key to initiate the microwave
leakage test. The oven will warm up to 500°F
(260°C). When warmup is complete, insert the
water load. Follow the steps on page 27.
Microwave Power Test
This test should only be performed by the
manufacturer.
Burn-In
Press the L3 soft key to initiate a 25-minute burn-in.
This feature helps ensure all cavity walls reach ther-
mal equilibrium before testing is conducted.
