3-96
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Procedures
PLATFORM_WCCP Messages
Error Message PLATFORM_VLAN-3-UNLOCK_FAIL: Failed to unlock vlan-id [dec],
associated mapped vlan id value [dec].
Explanation The switch failed to unlock a VLAN ID. The most likely cause is that the VLAN is
already unlocked. The first [dec] is the VLAN ID, and the second [dec] is the MVID.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 2-7.
PLATFORM_WCCP Messages
This section contains platform Web Cache Communication Protocol (WCCP) messages.
Error Message PLATFORM-WCCP-3-NO_LABEL: Cannot allocate WCCP Label
Note This message applies only to Catalyst 3750 and 3560 switches.
Explanation The WCCP label could not be allocated. This means that the hardware cannot be
programmed to implement WCCP redirection.
Recommended Action Reduce the number of interfaces configured for WCCP redirection or policy
based routing.
Error Message PLATFORM-WCCP-4-SDM_MISMATCH: WCCP requires sdm template routing
Note This message applies only to Catalyst 3750 and 3560 switches.
Explanation To support this feature, you need to enable the Switch Database Management (SDM)
routing template.
Recommended Action Modify the SDM template to enable the routing template. Use the sdm prefer
routing global configuration command, and then reload the switch by using the reload privileged
EXEC command.
