3-41
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Procedures
FM Messages
Error Message FM-3-NOTOBJECT: Invalid object (VLAN [dec], IDB [hex]) used in Feature
Manager operation.
Note This message applies only to Catalyst 3550 switches.
Explanation An internal software error has occurred. An invalid combination of VLAN and interface
descriptor block (IDB) values was passed to a software routine. [dec] is the VLAN ID, and [hex] is
the IDB value.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 2-7.
Error Message FM-3-NULLCPU: Sending traffic on empty [chars] label [dec] to CPU.
Note This message applies only to Catalyst 3550 switches.
Explanation An internal software error occurred. [chars] is the direction (input or output), and [dec]
is the label number.
Recommended Action Find out more about the error by using the show tech-support privileged
EXEC command and by copying the error message exactly as it appears on the console or system
log and entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported
problems. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 2-7 for more information.
Error Message FM-3-OUTTTABLE: Not in truth table: RACL [dec] VLMAP [dec].
Note This message applies only to Catalyst 3550 switches.
Explanation An unrecoverable software error occurred while trying to merge the configured output
features. The two [dec] values are internal code numbers for the results of the router ACL and VLAN
map configured on a particular Layer 3 interface.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 2-7.
