3-115
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Procedures
QOSMGR Messages
Error Message QOSMGR-4-ACTION_NOT_SUPPORTED: Action is not supported in policymap
[chars].
Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.
Explanation An action other than the set, trust, and police policy-map class configuration
commands was configured in a policy map. This is a hardware limitation. [chars] is the policy-map
name.
Recommended Action Configure only the supported actions of set, trust, and police when in
policy-map class configuration mode.
Error Message QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not supported in
classmap [chars].
Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.
Explanation An unsupported match class-map configuration command was configured in a policy
map and attached to an egress interface, or more than one match class-map command was
configured. This is a hardware limitation. [chars] is the class-map name.
Recommended Action Reconfigure the class map or the policy map. Use only the match ip dscp
dscp-list class-map configuration command in a policy map that is attached to an egress interface.
Only one match per class map is supported.
Error Message QOSMGR-4-COMMAND_FAILURE: Execution of [chars] command failed.
Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.
Explanation The command to configure a QoS setting failed. This is possibly due to lack of hardware
resources. [chars] is the description of the command.
Recommended Action Check if any other messages indicate resource failure. If other messages
indicate that the hardware resources are exceeded, retry the command with a smaller configuration.
Find out more about the error by using the show tech-support privileged EXEC command and by
copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about
these online tools and about contacting Cisco, see the
“Error Message Traceback Reports” section on
page 2-7.
