3-150
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Procedures
VQPCLIENT Messages
VQPCLIENT Messages
This section contains VLAN Query Protocol (VQP) client messages.
Error Message VQPCLIENT-2-CHUNKFAIL: Could not allocate memory for VQP.
Explanation An error occurred when the system tried to allocate memory for the VQP client.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 2-7.
Error Message VQPCLIENT-2-DENY: Host [enet] denied on interface [chars].
Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.
Explanation The VLAN Membership Policy Server (VMPS) has denied access for the given host
MAC address to an interface. [enet] is the host MAC address, and [chars] is the interface name.
Recommended Action No action is normally required. If you think that the host should have been
allowed access, verify the configuration on the VMPS.
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.
Explanation The system has shut down the specified interface because too many hosts have requested
access to that interface. [chars] is the interface name.
Recommended Action To enable the interface, remove the excess hosts, and enter the no shutdown
interface configuration command.
Error Message VQPCLIENT-3-IFNAME: Invalid interface ([chars]) in response.
Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.
Explanation The VMPS has sent an unsolicited response with an unknown interface name. [chars] is
the name of the unknown interface.
Recommended Action Verify the VMPS configuration.
