Filter
Top Products
Installation
5
Oven Assembly
PACKAGING
Before beginning assembly of the oven, check for
all necessary components. In addition to the oven
itself, legs, a proper vent, and/or other accesso-
ries may be required.
900 Series ovens are packaged as follows:
Single Section Ovens
Thefollowingarepackedintheoven:
D
A set of 27-1/2” (70 cm) legs with attaching
hardware.
D
Either a canopy or direct vent as specified
D
Either a natural gas or propane gas pressure
regulator as required.
Multiple Section Ovens
The following are packed inside the bottom sec-
tion:
D
A set of legs of the appropriate length
D
Either a canopy or direct vent as specified
D
A back pipe of appropriate length with either a
natural gas or propane gas regulator attached
Additional Packaging
D
Ultra Rokite decks for all 900 Series are packed
in a separate crate.
D
The top section of multiple section ovens will al-
ways have the crown angle in position.
LEG ATTACHMENT
1. Put the oven onto a lift with the bottom of the
oven down.
2. Each leg is attached by three bolts to the un-
derside of t he oven base frame.
Figure 2
CASTER ATTACHMENT
1. Bolt supports to oven with 1/2---13 hex head
bolts(casterswithbrakesshouldbefacing
front of oven.)
2. Carefully place oven onto t he casters. (It will
be necessary to have several persons lift oven
off the pallet and set it onto the casters). En-
gage brakes on front casters.
NOTE: A fixed restraint must be provided if cast-
ers are used in conjunction with a flexible
connector for movable appliances. This
restraint must secure the oven to a non -
movable surface to eliminate stress on the
connector. If the oven is moved, the re-
straint must be reconnected after the oven
is returned to it’s normal position.
Restraint Cable
Bracket
Figure 3