Filter
Top Products
8
• If food tends to stick to the sides of the blender jar when blending,
pulse in short bursts.
• Pulses should be short bursts. Space the pulses so the blades
stop rotating between pulses.
Don’t:
• Don’t store food or liquids in your blender jar.
• Don’t place cutting assembly and locking ring onto motor base
without the blender jar attached.
• Do not attempt to mash potatoes, knead heavy dough,
or beat egg whites. These can be done in the Food Processor.
• Don’t remove blender jar while unit is on. Keep the blender jar
cover on the blender jar while blending.
• Don't twist locking ring from blender jar when removing blender
jar from motor base. Simply lift blender jar from motor base.
• Don’t overprocess foods. Blender will achieve most desired results
in seconds, not minutes.
• Don’t overload blender. If the motor stalls, turn the blender off
immediately, unplug the unit, and remove a portion of the food,
then continue.
• Don’t use any utensil inside the blender jar while the motor is on.
• Don’t use any container or accessories not recommended by
Cuisinart
®
. Doing so may result in injury.
• Don’t place hands inside the blender jar when blender is
plugged in.
• Don’t add boiling liquids or frozen foods [except ice cubes or
1/2-inch (1.25 cm) pieces of frozen fruit] to glass blender jar. Boiling
liquids should cool for 5 minutes before being placed in blender jar.
FOOD PROCESSOR FEATURES
1. Food pusher with
oil dispenser
2. Work bowl cover with
feed tube
3. Stainless steel
chopping blade
4. Stainless steel reversible
slicing/shredding disc
5. Adapter stem
6. Clear work bowl
7. Gearbox collar
8. Motor base
Used for both the blender
jar and the food processor
bowl
FOOD PROCESSOR
GETTING STARTED STEP BY STEP
Please note that the bowl with collar will fit on the base in eight
different positions. The handle can be in front or on either side
and the feed tube in front, back, or on either side. Directions for
use reference a certain position for instructional purposes only.
FOOD PROCESSOR ASSEMBLY
CHOPPING, PURÉEING AND MIXING
1. Hold gearbox collar in one hand and work bowl handle in the
other. Twist bowl clockwise onto collar.
2. Place collar with bowl onto motor base with handle facing front.
3. Place chopping blade over shaft in work bowl. Chopping blade
should slide easily to the bottom of the bowl. Lower blade will
almost touch bottom of bowl.
BE SURE TO HANDLE THE METAL BLADE WITH CARE AS
IT IS RAZOR SHARP!
4. Place food to be processed in work bowl. Put cover on work
1
2
3
4
5
6
7
8
CBT-500FPPC_v2_IB_BIL 2/24/05 10:54 AM Page 8