Filter
Top Products
4-2
Operation - Standard Use 4
Essential Steps
Essential Steps
Here is a summary of the things you must do, and
the order in which you should do them.
1) Check that you have received all standard parts.
2) Connect the keypad.
3) Fit the fuses and connect the power supply cord.
4) Assemble and connect the probe (including the
support).
5) Connect the tubings.
6) Switch on the power supply.
7) Enter the configuration details using the keypad.
8) Fit the syringe or syringes.
9) Create and save a Method as a numbered file.
10)Prime the Dilutor-Dispenser.
11)Run the Method.
Standard Parts
If you have a Single-syringe or a Dual-syringe, check
that you have received all the parts in Appendix A.
Connect the Keypad
Connect the keypad as described in Chapter 3.
Fit the Fuses and Connect the Power
Fit the fuses and connect the power supply cord
(see Chapter 3).
Assemble and Connect the Probe
Assemble and connect the probe (see Chapter 3).
Connect the Tubing
If you have a Single-syringe 402, install the tubings
as described in Chapter 3, page 3-4. You must con-
nect 3 pieces of tubing: inlet (reservoir), transfer
(probe), and waste.