Filter
Top Products
5-24
Operation - Advanced Use 5
volume of liquid, is dispensed, at the end of the
process, into the waste.
When you configure disposable tips in air mode,
‘Extra volume’ is replaced by ‘Air push volume’ in
this task.
1. Aspirate an air gap.
2. Aspirate liquid via the probe.
3. Dispense fractions via the probe.
4. Dispense extra volume to waste.
Typical Task Entry
Key in the File # (e.g. 45), ENTER.
Press Edit.
Disp, then press Chge
to switch source.
Now, you may select
one of two modes,
where:
(a) Fractions are equal,
(b) Fractions are different.
Press Chge to change modes, then ENTER, Next.
Key in number of
fractions, then ENTER,
Next.
For SAME mode, key
in ‘Common volume’,
for DIFFERENT
mode, key in volume
for fraction 1.
Press Next, key in
volume for fraction
2, Next, etc.
Press ENTER, Next.
Optionally press Extra (only if source is probe),
Key in ‘Extra volume’, press ENTER, ESC.
At the last volume screen the Adj key replaces Next.
Optionally, press Adj.
Press Chge to switch source, ENTER, then Next.
Key in the final volume, ENTER, ESC.
After the data are entered the Adj key is shown as
ADJ.
Optionally at the last of the volume screens, press Flow.
Key in a value for Asp
flow, press ENTER.
Press Next.
Key in a value for Disp
flow, press ENTER.
Software