Henny Penny EEE-142 Fryer User Manual


 
Model EEE-141,142, 143, 144
6. Once oil has drained from vat, use the lift tool and lift the hinged
element from the vat to clean the bottom of the vat. Figure 2.
(Auto-lift fryers, hinge back the basket hooks over the top of
the fryer before lifting the elements.)
Use protective cloth or gloves when lifting the element
with the lift tool. The element may be hot and severe
burns could result.
Avoid putting the lift tool in the center of the elements, at
the same area as the high limit bulb, or damage to the high
limit could result.
7. Scrape or brush the sides and the bottom of the vat. Be
careful not to damage the sensing probes.
Do not use steel wool, other abrasive cleaners or cleaners/
sanitizers containing chlorine, bromine, iodine or ammonia
chemicals, as these will deteriorate the stainless steel
material and shorten the life of the unit.
Do not use a water jet (pressure sprayer) to clean the unit,
or component damage could result.
8. Once the vat is clean and the display shows
“SCRUB VAT COMPLETE?” “YES NO”. Press
button
for YES and the display shows “WASH VAT” “YES NO”..
9. Lower the element and then press
button and display
shows “WASHING”. The oil circulates through the vat for
several minutes. Once the wash cycle is complete, display
shows “WASH AGAIN?” “YES NO”.
10. Press
button for YES if another wash is needed, otherwise
press X button for NO and the display shows “CLOSE
DRAIN” Push-in on the drain knob to close the drain (Figure
3) and the display shows “RINSING” and vat fills with oil.
11. Once the vat is filled, “OPEN DRAIN” shows in display. Pull-
out on drain knob to open the drain (Figure 4) and display
shows “RINSING”. When rinsing is complete, display shows
“RINSE AGAIN?” “YES NO”.
110 3-14
Figure 3
3-12. DAILY FILTERING
(Continued)
Figure 4
Figure 2