Filter
Top Products
Model EEE-141,142, 143, 144
To Change Times and Temperatures
7. Press button until “COOK TIME” shows in the display,
and then use the product buttons, or the and buttons, to
change the time in minutes and seconds, to a maximum of
59:59.
8. Press button and “TEMP” shows in the display, along with
the preset temperature on the right side of the display.
Press the product buttons, or the and buttons, to
change the temperature. The temperature range is 190°F
(88°C) to 375°F (191°C).
Cook ID Change
9. Press button until “COOK ID” shows in the display
along with the product ID. For example, NUG would be the
ID for nuggets. Use the product buttons, or the and
buttons, to change the ID.
Alarms (1 & 2)
11. Press button until “ALRM 1” shows in the left display,
and an alarm time in the right display. Press the product buttons,
or the and buttons, to set an alarm.
Ex., If a Cook Cycle was set at 3 minutes, and an alarm was to
go off after 30 seconds into the Cook Cycle, “2:30” would be
set in the display at this time. When the timer counts down to
2:30 the alarm sounds.
After the alarm time is set, press button and “ALRM 2”
shows in the display, and a second alarm can be programmed.
Quality Timer (hold time)
12. Press button until “QUAL TMR” shows in the display
along with the preset holding time. Press the product buttons,
or the and buttons,to adjust holding time, up to
59:59.
Global Filter Tracking
Include in Filter Count
13a. Press button until “INCL IN FLTR CNT” flashes in the
display along with “YES” or “NO”. Using and
buttons, change the display to “YES” if that product’s Cook
Cycles are to be counted as part of the recommended filter
process. Set to “NO” if it is not to be included.
5-2 309
5-1. MODIFYING PRODUCT
SETTINGS (Continued)