Filter
Top Products
– 15 –
Clean the mixer with a hot damp cloth, thoroughly wipe the bowl arms and all exterior surfaces.
The drip cup should be removed and cleaned periodically (at least once per week depending
on use) and wiped clean. Do not operate the mixer without the drip cup.
USING THE ATTACHMENT FACILITY.
SAFETY INSTRUCTIONS
The following instructions must be observed when using the mixer with attachments.
THE ATTACHMENT AND/OR MIXER SHOULD ONLY BE USED BY A FULLY
TRAINED AND COMPETENT PERSON.
• Do not fit an attachment while the mixer is operating.
• Do not wear loose clothing.
• Do not use the mixer or attachment if a fault develops or the machine is unsafe.
• Do not access rotating parts.
• Do not use excessive force when operating the attachment which could affect the
stability of the mixer.
• Do not operate the mixer if parts are disassembled.
• Always use the attachment and/or mixer in a well lit area.
• Always ensure the attachment is operating at the correct speed.
• Always ensure the bowl, bowl clamps, attachment and guard are correctly fitted to the
machine.
• Always use the toggle switch ‘O’ to stop mixer.
• Always disconnect the mains electricity supply before cleaning.
• Always clean the attachments after use and refer to the attachment manufacturer’s
cleaning instructions.
• Always service your mixer and attachments regularly; at least twice a year depending
on the frequency of use.
• Only use attachments approved by Hobart.
FITTING AN ATTACHMENT.
To install an attachment, ensure the electricity supply is isolated. Loosen the thumb screw
situated on the attachment hub (see Figure 1). Swivel the hub guard to one side and insert the
attachment into the hub. Ensure the square shank of the attachment locates in the square drive
of the mixer. Secure the attachment by tightening the thumb screw.
The selected mixer speeds will be determined by the type of attachment fitted.