Filter
Top Products
– 6 –
SAFETY INFORMATION.
The information in this manual has been prepared to assist the operator to understand,
maintain and operate the N50 mixer. Before installation or operating for the first time, this
manual must be studied to obtain a clear understanding of the mixer and its capabilities.
To prevent accidents, read, understand and follow all the precautions and warnings contained
in this manual before operating or carrying out any of the cleaning/maintenance operations.
For warning information see the section below, the section on ‘commissioning and operation’,
and ‘using attachments’. The procedures and precautions contained in this manual are
understood to apply to the machinery only when it is used in the authorized manner. If the
machinery is used other than in the authorized manner, the operator will be responsible for
his/her own safety and for the safety of the other persons who may be involved.
• Ensure this manual is kept in an easily accessible place for future reference near the mixer.
• All operators must be trained in the safe operation of the mixer and attachments.
• Do not remove any covers or loosen any fittings while the mixer is operating.
• Ensure the electrical supply has been isolated before attempting to service or move the
mixer.
• Rotating machinery and electricity are potentially hazardous and may cause injury if
sufficient precautions are not taken prior to operating or servicing the machine.
• Always have your mixer and attachments regularly serviced at least twice a year,
depending on the frequency of use.
• Do not hose or pressure clean this appliance. Follow the cleaning instructions detailed in
this manual.
WARNING SYMBOLS.
To identify the safety messages in this manual, the following symbols have been used:
The “Warning” symbol is found primarily where the corresponding information is
important for the safe use of the machinery.
The electrical hazard symbol is used when there are risks of an electrical nature.
Prior to servicing the machinery, always disconnect the power cable from the
mains supply.