Filter
Top Products
– 9 –
TABLE 1. TECHNICAL INFORMATION.
Description Units Value
Electrical supply range 230 volts, 50 Hz, single phase
Motor power kW (HP) 0.13 (1/6)
Maximum speed of rotating part RPM 1425
Full load current Amps 1.7
Locked rotor current Amps 12.5
Maximum ambient temperature
o
C40
Attachment hub drive size Number 10
Mixer weight including agitator Kg (Lbs) 21.5 (46)
and bowl (empty)
Bowl weight (empty) Kg (Lbs) 0.74 (1.6)
Noise level dB(A) Less than 70
Shipping weight Kg (Lbs) 25.7 (55)
Shipping dimensions (carton) L x W x H mm 505 x 375 x 470
Storage conditions. Maximum
o
C, % RH 38, 85
temperature and humidity.
INSTALLATION.
There are no specific requirements for the installation of the mixer. The mixer is supplied with
a mains electricity plug. Ensure the following sections are read before operation.
UNPACKING.
Carefully unpack the machine. Do not use a sharp knife to cut into the box as damage to the
machine may occur. Check for possible shipping damage. If the unit is found to be damaged,
save the packaging material and contact your nearest Hobart sales office. Refer to Table 1 for
mixer weights prior to lifting.
LOCATION.
Select a suitable flat level counter top that can support the weight of the mixer and
bowl contents when full (see Table 1 for mixer weights). The mixer stands on
rubber feet and does not need to be secured to the work surface. Ensure there
is sufficient space around the mixer to enable safe operation of the bowl lift
handle, attachment hub and removal/replacement of the mixing bowl. Servicing
may be more difficult because of reduced clearances and you should always check that
equipment specifications permit the close proximity of other equipment. Refer to Figure 1 for
the overall dimensions of the mixer.