Filter
Top Products
Technical Information
CVA615 Coffee System
6.4 Fault Diagnosis
When two cups of coffee / espresso are being prepared at the same
time, the cups are filled unevenly.
Appliance is not level.
- Level the appliance
Coffee nozzle is dirty.
- Clean the coffee nozzle.
Brew Unit cannot be removed from the appliance.
The brew unit is not in the starting (home) position.
- Reset the brew unit to the starting (home) position.
The brew unit is jammed and cannot be removed by resetting the
appliance (i.e. shutting the door and turn on the power).
- Perform the manual removal procedure.
Inspect the brew unit and/or drives to locate fault.
Brew Unit cannot be installed
The part marked PRESS was pressed during installation of the Brew
Unit.
- Do not press the part marked PRESS when installing the Brew Unit;
this only applies during Brew Unit removal.
The Brew Unit is not in the starting (home position).
- Perform a manual resetting of the Brew Unit.
The drive shaft is not in the starting (home) position.
- Reset the Brew Unit to the starting (home) position via the Service
Mode.
- Carefully inspect the Brew Unit and/or drives to locate fault (i.e.
defective switch etc...)
103