Filter
Top Products
Technical Information
CVA615 Coffee System
5.44 Water Path Leakage Test
In the event water is present in bottom of the appliance, or a leak is
suspected; the following procedure will help in locating the source of the
leak.
Caution!
Heaters can be hot during this test and hot water may escape from the
system.
1. Fill the Water reservoir completely
2. Place the appliance into the Service Mode with the Selector Knob in
the Programming position. Refer to Section 6 - Fault Diagnosis for
further information on service mode access.
3. Press and hold all three coffee buttons - check for signs of leakage
(dripping, squirting etc...)
4. Release the three coffee buttons to end the test
If steps 1-4 do not disclose any leaks - continue as follows.
5. Fill the Water reservoir completely
6. Place the appliance into the Service Mode
7. Quickly turn the selector knob to the “Operation” position
8. Press and hold all three coffee buttons for 30 seconds
9. Quickly turn the selector knob to the “Programming” position
10. Press and hold all three coffee buttons - check for signs of leakage
(dripping, squirting etc...)
11. Release the three coffee buttons to end the test
96