Filter
Top Products
Technical Information
CVA615 Coffee System
5. Rub away coffee residues from the steel filters with a sponge.
6. Dry the funnel to prevent ground coffee from sticking.
7. After cleaning press "PRESS".
8. Remove the Waste Container (if re-installed).
Figure 5-20: Brew Unit Installation
9. Push the brew unit in the track straight into the appliance without
pressing "PRESS" until it clicks in place (refer to Figure 5-20 – Brew
Unit Installation).
5.24 Brew Unit – Filter Cleaning
1. Remove the Brew Unit – Refer to Section 5.20.
2. Wipe away coffee residues from the steel filter in the funnel of the
brew unit with a sponge.
3. The filters can be removed for thorough cleaning.
4. Fit a 5mm allen wrench to the connection point in the brew unit. Turn
counterclockwise while supporting the chrome filter from below.
Remove the filter by lifting it from the brew unit.
5. Access the second filter by placing a long shaft Philips Screwdriver
through the center of the funnel and remove the screw in the center
of the filter.
6. Manually move the brew unit into the “brew position”.
7. Turn brew upside down – filter will fall out.
8. Clean both sides of the filter with hot water and dry.
9. Re-install the second filter back in position.
10. Manually move the Brew Unit to the “home position”
11. Re-install the Philips screw in the center of the filter.
12. Return the first filter to the brew unit and secure by turning the allen
wrench clockwise.
68