Filter
Top Products
Technical Information
CVA615 Coffee System
20. Remove the knobs from the Grinder Slide Controls.
21. Remove the Adjustment Slide Switch Frame (5.4).
22. Position the Grinder as necessary to access the Drive Cover and
Drive Unit Retaining Screws. Refer to Figure 5-34 for the location of
the screws.
23. Remove the two Upper Front Plate Assembly Retaining Screws – as
shown in Figure 5-35.
24. Remove all remaining screws from the Front Plate Assembly. Lift
upward on the Front Plate Assembly to access the screws near the
bottom of the plate. Use Figure 5-32 to locate all screws.
Figure 5-35: Upper Front Plate Assembly Retaining Screws
25. Move the Drive Assembly Cover toward the rear wall of the appliance.
26. Move the Drive Assembly back while lifting upward to remove it from
the appliance. Use caution – a short length of wiring.
80