Filter
Top Products
Overview
8
Related Documents
The following documents are related to this manual:
Manual Part Number
Description
Agilent 66000A MPS Mainframe
Installation Guide
66000-90001
Provides product specifications, installation, and
connection information.
Agilent Series 6610xA MPS Power
Modules User’s Guide
5959-3386
Describes the operation of the MPS Power Modules.
Agilent Series 6610xA MPS Power
Modules Programming Guide
5959-3362
Describes SCPI programming commands, status
reporting.
Agilent Series 66000A MPS
Mainframe Service Manual
66000-90003
Provides replaceable-parts lists, circuit diagrams, and
verification procedures for the Agilent Series 66000A
MPS Mainframe.
Revisions and Updates
Manual
Agilent Technologies instruments are identified by a two-part, ten-character serial number, such as 3246A-00517. The first
five characters (e.g. 3246A) are the serial prefix, which is the same for all identically made instruments. The last five digits
(e.g. 00517) are a unique serial number assigned to each instrument. If a significant design change is made, the prefix
changes but the last five numbers continue in sequence.
This manual applies to Agilent 6610xA Power Modules with the same serial prefixes and serial numbers equal to or higher
than the ones shown on the title page. If the prefix number on your power module is higher than the one on the title page,
then the module was made after publication of the manual and may have hardware and/or firmware differences not covered
in the manual. If there are such differences, they are documented in one or more "Manual Changes" sheets sent with the
manual.
If the prefix number on your power module is lower than the one on the title page, then the module was made before the
publication of the manual and may have differences not covered in the manual. These differences are documented in
appendix A.
Firmware
This manual applies to power modules that run on software revision A.00.01 through A.00.04. Firmware revision A.00.04 is
backward compatible with all previous revisions. The ROM chip (U2) has a label that specifies the firmware revision.