Filter
Top Products
Installation
6
Leg Attachment
LEG OPTIONS
Legs are available in 4” (101mm), 6” (152mm) or
25” (635mm) lengths or low profile casters.
D
The 4” (101mm) legs may be used when mount-
ing on a counter.
D
The 6” (152.4mm) legs are used on the lower
section of a double stacked appliance.
D
The 25” (635mm) legs are used for a single ap-
pliance located on the floor.
NOTE: For safety reasons, casters must not be
used with the 25” (635mm) legs.
4” (101mm) Leg
6” (152,4mm) Adjustable Leg
Low Profile Casters
25” (635mm) Adjustable Leg
Figure 2
ATTACHMENT
1. Align the threaded stud on one of the front
legs to the bolt hole located in the bottom cor-
ner of the appliance. Tu rn the leg clockwise
and tighten to the nearest full turn.
2. Align the leg plate holes with the bolt holes.
Secure with the two 1/2” bolts provided.
3. Repeat the above steps with the other front
leg. If low profile casters are used, install them
with the locking casters in the front of the oven.
The rear casters do not lock. Ensure that the
locksaresetonthefrontcasters.
4. Tip t he oven up on the new ly installed front
legs. If casters are used, check that the locks
aresetonthefrontcasters.Repeat the above
steps for the rear legs.
5. Except for appliances with casters, level the
oven by screwing the adjustable feet in or out
as necessary.
Figure 3