Filter
Top Products
Installation
13
Gas Hose Restraint
If the appliance is mounted on casters, a commer -
cial flexible connector with a minimum of 3/4” (1.9
cm) inside diameter must be used along with a
quick connect device.
The restraint, supplied with the appliance, must be
used to limit the movement of the appliance so that
no strain is placed upontheflexible connector. The
restraint should be fastened to the base frame of
the oven as close to the flexible connector as pos-
sible. It should be short enough t o prevent any
strain on the connector. W ith the restraint fully
stretched the connector should be easy to install
and quick connect.
The restraint (ie: heavy gauge cable) should be at -
tached without damaging the building. DO NOT
use the gas piping or electrical conduit for the at-
tachment of the permanent end of the restraint!
Use anchor bolts in concrete or cement block. On
wooden walls, drive hi test wood lag screws into
the studs of the wall.
WARNING!!
If the restraint is disconnected for any rea-
son it must be reconnected when the ap-
pliance i s returned to its original position.
U.S. and Canadian installations
The connector must comply with t he Standard for
Connectors for Movable Gas Appliances, ANSI
Z21.69 or Connectors For Mov eable Gas Ap-
pliances CAN/CGA -6.16 and a quick disconnect
device that complies with the Standard for Quick-
Disconnect Devices for Use With Gas Fuel, ANSI
Z21.41 or Quick Disconnect For Use With Gas Fuel
CAN 1-6.9. Adequate means must be provided to
limit the movement of the appliance without de-
pending on the connection and the quick discon-
nect device or its associated piping.
A drip leg must be used at each appliance. Refer
to NFPA54/ANSI Z223.1 - Latest Edition (National
Fuel Gas Code) for proper drip leg installation.
General export installations
Install ati on must co nfo rm with Lo cal and National
instal lati o n standards. Local i nstall ati on co des and/
or requi rements may vary. If you have any questi o ns
regarding the proper installation and/or operation of
your appl i ance, please contact y our l o cal di stri butor.
If yo u do n ot hav e a l ocal distributor, please cal l
Blodgett Combi at 0011-802-860-3700.
Gas Supply Line
Gas Hose
Quick Connect
Installation of Gas H ose and Restraint
(Single Section Shown)
Attachment Plate
(secure with leg mount bolt)
IMPORTANT: Cable restraint should
be fastened as close as possible to the
flexible connector and short enough to
prevent any strain on the flexible con-
nector.
At maximum stretch of shortened re-
straint, the flexible connector should
be easy to installand quick to connect.
Restraint
Figure 9