Filter
Top Products
Operation
32
Blodgett IQ2T Cont rol
PROGRAMMING MULTIPLE STAGE RECIPES
Entering the Programming Mode:
1. Press and hold the PROGKEY(9). The topdis-
play reads CodE.
2. Use the product keys to enter the program-
ming access code: 3 1 2 4. Press t he ENTER
KEY (13). The top display reads Prod.
3. Press the desired product key followed by the
ENTER KEY (13).
Programming the Cook Time:
NOTE: When multiple stage cooking is being
used, the countdown time displayed dur-
ing cooking is the sum of all stages.
1. The top display reads P1:__. The bottom dis-
play gives the current programmed cook time
for stage 1 in minutes:seconds. Press the
TOGGLE/CLEAR KEY (10). Use the product
keys to enter the new cook time. Press theEN-
TER KEY (13) to save the new cook time.
2. The top d isplay r eads P2 :__. The control is
asking for the cook time for the second stage
of this recipe. Repeat Step 1 for each addition-
al stage.
3. When the cook times for all stages are pro-
grammed, press the TOGGLE/CLEAR KEY
(10) to clear the bottom display.
NOTE: This tells the controller that there are
no more stages for this recipe. Once
the number of stages has been estab-
lished the control will only allow en -
tries for these stages on all further pa-
rameters for this product.
4. Press the ENTER KEY (13) again. The display
reads P1:. The bottom displayshows the cook
time.
5. Press t he SCAN KEY (14) to advance the pro-
gramming mode to cook temperature.
Programming the Cook Temperature:
1. The top display reads C t --- 1 . The bottom dis-
play gives the current cook temperature for
stage 1 of this recipe. Use the product keys to
enter the desired cook temperature.
2. Press the ENTER KEY (13) to save the new
cook temperature for stage 1. The top display
read s Ct --- 2.
NOTE: Repeat Steps 1---2 to program the
cook temperature for additional
stages. When the cook temperature
for the final stage has b een entered
the top display reads Ct---1.
3. Press t he SCAN KEY (14) to advance the pro-
gramming mode to fan speed
Programming the Fan Speed:
NOTE: The DFG-50 is single speed only.
1. The top display reads SPd1. The bottom dis-
play reads HI. Press the SCAN KEY (14) to ad-
vance the programming mode to the fan cycle
time.