Filter
Top Products
U s e r I n s t a l l a b l e F e a t u r e s
LifeBook 900 Series from Fujitsu
119
7. Slide the device forward until the unit is clear
of the compartment.
To Remove a Device from Multi-function Bay 2
5. Slide the release button at the left rear corner
of Multi-function Bay 2 toward the outer
edge of your notebook.
6.
Twist the release but ton tow a rd the front of
your notebook until the devi ce in the bay pop s
forw a r d sligh t ly.
7. Grasp the device by the left corner and
slide it forward until the device is clear
of the compartment.
Release
Figure 4-3 Removing and Installing a
Device in Multi-function Bay 2
C A U T I O N
Be careful aligning and seating devices
in the bay. If the fit is incorrect you may
damage the bay or the device. If the
device does not move easily, remove
it, and check for dirt or foreign objects.
It will require a firm push to latch the
device in place.
Eject
Multi-function Bay 2 Device
Multi-function
Bay 2 Release
Button
Device Connector
UP
To Install a Device in either
Multi-function Bay 1 or 2
1. If you are swapping a device your computer
should already be suspended. If it is not, go
through steps 1 to 4 of the previous section
(Removing a Device in Multi-function
Bay 1 or 2) to place your notebook in
Suspend mode.
2. Turn your notebook upside down with the
bay openings toward you.
C A U T I O N
The front panel of the CD-ROM drive
must be treated gently when removing the
drive from the Multi-function bay or the
drive can be damaged.